Trip from Bedford Hills, NY to New York City, NY

Drive Time

1h 11m

Distance

44.5 mi

72 km

Drive Score

6/10

Good drive

Same Day?

Yes, doable

Fuel Cost

$7

one way

Best Time to Leave

Save up to 17 min
4 AM
1h 6m ★
6 AM
1h 12m
8 AM
1h 23m
10 AM
1h 16m
12 PM
1h 15m
3 PM
1h 17m
5 PM
1h 23m
8 PM
1h 9m

Estimated drive times based on typical traffic patterns. Actual times may vary with weather, construction, and real-time conditions.

Downtown Bedford Hills, NY, NY

Bedford Hills, NY

Abhishek Navlakha

Downtown New York City, NY, NY

New York City, NY

Renan Tagliaferro

Trip Overview

Traveling from Bedford Hills to New York City is a straightforward 44.5-mile journey that typically takes about 1 hour and 11 minutes. Because of the manageable distance, this route is perfectly suited for a single-day excursion, requiring no overnight stops. Budgeting approximately $7 for fuel makes this a cost-effective way to transition from the northern Westchester suburbs into the heart of the city. Since both locations are situated within the Northeast region, you will experience a consistent cultural and geographic transition as you move toward the urban center. This drive is highly practical for those looking to reach the city quickly without the complexity of a multi-day itinerary.

Trip Pace

Same-day drive is realistic

A same-day return is realistic if you keep stops short.

Break Rhythm

0 planned breaks

A short stop every 2 to 3 hours is enough for this drive.

Midpoint

22.2 miles from Bedford Hills, NY

A natural place for your longest stop of the day , about 31m into the drive .

Drive Character

This trip is a highway-focused drive, with 86% of your time spent on major thoroughfares. You will start by navigating the Saw Mill River Parkway, which accounts for the longest uninterrupted stretch of the trip at 27.5 miles. As you progress, the route transitions into the Henry Hudson Parkway before eventually funneling onto 12th Avenue. Expect a steady, fast-paced experience that requires your full attention as the suburban parkway environment gradually gives way to the dense traffic patterns of the city. The character of the road is functional and direct, prioritizing efficiency over leisure as you make your way south.

Most of the miles stay on highways, which makes pacing and fuel planning easier than turn-by-turn city driving.
There are about 16 navigation steps in the underlying route data, so the final approach matters more than the middle miles.
Saw Mill River Parkway is the longest continuous segment at about 27.5 miles.

How Hard Is This Drive?

This is a straightforward highway drive that stays mostly on Saw Mill River Parkway and Henry Hudson Parkway. You will hit about 9 points where you need to pay attention to lane position or signs. The trickiest moment comes around 0.3 miles in near Adams Street.

Route Complexity 6/10

Moderate - straightforward overall, but long enough or busy enough to require pacing

This drive requires moderate attention. Across 44.5 miles you will encounter 9 spots where lane choice or exit timing matters. Not difficult for experienced highway drivers, but worth previewing the tricky sections before you go.

Where does it get tricky?

The main spots that need attention: at 0.3 miles (Adams Street): Navigation decision point; at 0.4 miles (NY 117 / Bedford Road): Lane positioning matters here; at 0.7 miles (Saw Mill River Parkway): Merge point - match speed before joining. Lane positioning matters here.

Critical Maneuvers

5 of 9 key points

These are the spots where you need to pay the most attention. Preview them before you drive.

5
0.3 mi into trip | ~0m in | Adams Street

At end of road, turn left onto Adams Street

Navigation decision point

8
0.4 mi into trip | ~1m in | NY 117 / Bedford Road

At end of road, turn right onto NY 117 / Bedford Road

Lane positioning matters here

Use the straight lane.
5
0.7 mi into trip | ~1m in | Saw Mill River Parkway

Merge onto Saw Mill River Parkway

Merge point - match speed before joining. Lane positioning matters here

Use the none lane.
7
28.6 mi into trip | ~40m in | HH / Henry Hudson Parkway

Keep slight right at fork onto HH / Henry Hudson Parkway toward Henry Hudson Parkway South

Highway fork - watch signs carefully. Lane positioning matters here

Use the none lane. Toward Henry Hudson Parkway South
5
43.9 mi into trip | ~1h 9m in | Chambers Street

Turn left onto Chambers Street

Lane positioning matters here

Use the left lane.

Towns Along This Route

On the drive from Bedford Hills, NY to New York City, NY, road signs begin pointing toward Henry Hudson Parkway South along the way.

Henry Hudson Parkway South

28.6 mi in | ~40m | via HH

Main Roads

Road Distance Duration
Saw Mill River Parkway 27.5 mi 37m
Henry Hudson Parkway 10.9 mi 16m
12th Avenue 1.8 mi 5m
West Street 1.8 mi 5m
West Side Highway 0.8 mi 1m
11th Avenue 0.4 mi 1m
Chambers Street 0.3 mi 1m
Babbitt Road 0.3 mi <1m
Longest stretch: Saw Mill River Parkway — 27.5 mi, about 37m

Turn-by-Turn Driving Directions

Step-by-step road directions between Bedford Hills, NY and New York City, NY.

1

Start on Babbitt Road

0.3 mi · 46 sec · Babbitt Road
2

At end of road, turn left onto Adams Street

0.1 mi · 18 sec · Adams Street
3

At end of road, turn right onto NY 117

0.2 mi · 31 sec · Bedford Road
Use the straight lane.
4

Take the ramp

427 ft · 11 sec
5

Merge onto Saw Mill River Parkway

27 mi · 37 min · Saw Mill River Parkway
Use the none lane.
6

Continue on HH

0.4 mi · 32 sec · Henry Hudson Parkway
7

Keep slight right at fork onto HH

11 mi · 16 min · Henry Hudson Parkway
Toward Henry Hudson Parkway South Use the none lane.
8

Continue on NY 9A

0.8 mi · 1 min · West Side Highway
Use the none / straight / slight right lanes.
9

Continue on NY 9A

1.8 mi · 5 min · 12th Avenue
Use the none lane.
10

Continue on NY 9A

0.4 mi · 1 min · 11th Avenue
Use the none lane.
11

Continue on NY 9A

1.8 mi · 5 min · West Street
Use the straight lane.
12

Turn left onto Chambers Street

0.3 mi · 1 min · Chambers Street
Use the left lane.
13

Turn left onto Church Street

458 ft · 25 sec · Church Street
14

Turn right onto Duane Street

0.1 mi · 27 sec · Duane Street
15

Turn right onto Broadway

379 ft · 18 sec · Broadway
16

Arrive at destination

Broadway

Trip Plan

To ensure the smoothest transit, plan your departure around the typical peak traffic hours that affect these major parkways. Since the drive is short and requires zero planned stops, you have the flexibility to depart whenever your schedule permits, though staying aware of real-time congestion on the Saw Mill River Parkway is vital. Given the $7 fuel estimate, you will likely find that filling up before you leave Bedford Hills is the most convenient option. Keep in mind that once you reach 12th Avenue, the driving environment changes significantly, so stay alert for the shift from high-speed parkway travel to urban street navigation. Use this flexibility to your advantage by checking traffic reports immediately before you head out.

Morning Departure

Leave by 9 AM and you'll arrive before lunch.

Evening Departure

Even a 4 PM departure gets you there before dark in summer.

You can normally do this drive in one day.
You may only need one short stretch break if traffic stays light.
The halfway point lands around 22.2 miles from Bedford Hills, NY, or about 31m into the drive.
The longest continuous stretch on this route runs about 27.5 miles.

This is a comfortable same-day trip.

Departure

Before you leave

Start with fuel, water, and navigation already sorted so the first hour feels easy.

First stop

Around 44.5 miles or 1h 11m in

Use this first pause for coffee, a restroom break, and a quick traffic check ahead.

Halfway reset

Around 22.2 miles or 31m in

This is the best place for your longest stop, a real meal, and a full fuel check.

Final approach

Final hour starts around 54m

Traffic, exits, and arrival timing usually matter more near New York City, NY than in the middle of the route.

Before You Leave

+

Open the route before leaving Bedford Hills, NY so your first major turns are already loaded.

+

Leave with enough water and a charging cable within reach, not packed away.

+

Check your fuel range against the first long segment, especially if you are starting outside city service areas.

Day 1

Settle into the route from Bedford Hills, NY

This is one driving day of about 44.5 miles and 1h 11m.

Your first comfortable stop window is around 80 miles from Bedford Hills, NY.
This route can stay practical as a one-day drive if traffic stays reasonable.
You may only need one short stretch stop if conditions stay smooth.
The longest stretch is on Saw Mill River Parkway for about 27.5 miles.

Where to Stop

Rest stops, refuel points, and overnight suggestions along this route.

Halfway Point

Midpoint

About 22.2 mi from Bedford Hills, NY · 31m into the drive

Downtown Greenburgh, NY, NY

Mid-route town

Meal stop

Greenburgh, NY

22 mi into the route

Best for: Lunch, fuel, and a longer reset

This sits close to the middle of the route, so it works well for the longest stop of the day.

Popular next leg

Greenburgh, NY to New York City, NY

29.6 mi · 51m

Pacing Suggestions

Brooklyn, NY

Fuel and coffee

A short stop after about 44.5 miles helps settle the day before fatigue starts building.

Greenburgh, NY

Meal break

The midpoint is around 22.2 miles from Bedford Hills, NY, which is a good place for a longer meal and fuel stop.

Arriving in New York City, NY

The final approach into New York City, NY usually feels slower than the middle of the drive, so avoid planning your tightest schedule at the very end.

Try to arrive with enough fuel left to skip an immediate station stop unless you already know the area around New York City, NY.

These stop ideas are pacing suggestions — the exact town or exit can change with traffic, hotel plans, and fuel range.

Fuel & Cost

Regular Gas

$7.24 one way

$14.49 round trip

$4.14/gal 25.4 MPG avg 16 kg CO2
Fuel Type $/gal One Way Round Trip
midgrade $4.48 $7.85 $15.70
premium $4.88 $8.55 $17.11
diesel $5.64 $9.89 $19.77

No toll roads detected on this route.

Estimated Trip Cost (one way, 1 person)

Fuel

$7

Meals

$25–$50

Total

$32–$57

Rough estimate based on US averages. Hotel $80–$140/night, meals $25–$50/day.

Estimated CO2 emission: 15.6 kg one way. Prices: EIA weekly data, 2026-04-06.

Driving Electric?

About $5 in charging · 0 stops · 69% less CO2

Vehicle Type kWh Stops DC Fast Home Charge
Average EV 13.4 0 $4.67 $2.14
Efficient EV 11.1 0 $3.89 $1.78
EV Truck/SUV 17.8 0 $6.23 $2.85

Gas CO2

16 kg

EV CO2

5 kg (69% less)

This trip is well within single-charge range for most EVs. No charging stops needed if you start fully charged.

DC fast charging avg $0.35/kWh. Home charging avg $0.16/kWh. US grid CO2: 0.39 kg/kWh.

Travel Intel

Current conditions at both ends of the drive.

Forecast data refreshed 2 days ago

Origin

Bedford Hills, NY

Afternoon in Bedford Hills on Sunday

Local time

3:57 PM

EDT

Current temp

57°F

Unavailable

Live forecast

Destination

New York City, NY

Afternoon in New York City on Sunday

Local time

3:57 PM

EDT

Current temp

61°F

Unavailable

Live forecast

Seasonal Notes

Summer travel usually means heavier construction, hotter rest stops, and busier weekend traffic around major cities.

Winter travel shortens daylight, so a route that looks manageable on paper can feel much longer after dark.

Holiday weekends tend to make both departure and arrival windows slower than the raw route time suggests.

Time zone

Same local time

Origin and destination are on the same clock, so arrival timing is easier to judge at a glance.

Temperature spread

4 degrees warmer at arrival

A meaningful temperature swing is a good cue to rethink layers, water, and how soon you want to arrive.

Road read

1h 11m on the road

Use the two city cards together: check the sky where you start, then compare it with the local time and temperature at arrival.

Weather data from the National Weather Service. Conditions may change; check closer to your travel date.

Frequently Asked Questions

The drive from Bedford Hills, NY to New York City, NY covers 44.5 miles and takes about 1h 11m without stops. Add 15-30 minutes for a fuel or rest stop on longer drives.
The main roads are Saw Mill River Parkway, Henry Hudson Parkway, 12th Avenue. Most of the drive stays on highways, so watch for ramps and exits.
This is a comfortable same-day trip.
The midpoint is about 22.2 miles from Bedford Hills, NY. Look for rest areas, gas stations, or food options near the halfway mark.
At current regular gas prices, expect to spend about $7.24 one way. This estimate uses 25.4 MPG — your actual cost will vary with your vehicle's fuel efficiency and current gas prices.
Leave by 9 AM and you'll arrive before lunch. Even a 4 PM departure gets you there before dark in summer.
This drive requires moderate attention. Across 44.5 miles you will encounter 9 spots where lane choice or exit timing matters. Not difficult for experienced highway drivers, but worth previewing the tricky sections before you go.
The main spots that need attention: at 0.3 miles (Adams Street): Navigation decision point; at 0.4 miles (NY 117 / Bedford Road): Lane positioning matters here; at 0.7 miles (Saw Mill River Parkway): Merge point - match speed before joining. Lane positioning matters here.
On the drive from Bedford Hills, NY to New York City, NY, road signs begin pointing toward Henry Hudson Parkway South along the way.

Was this route helpful?

Thanks for your feedback!

Your tip has been submitted. Thanks!

/500

Explore More

Return Trip

New York City, NY to Bedford Hills, NY

Plan the drive back the other way.

44.1 mi 1h 12m

Explore more options from Bedford Hills, NY or browse trips ending in New York City, NY.

Looking for more statewide routes? Browse NY road trips.

Explore maps for Bedford Hills, NY or New York City, NY on MapSof.net.