Trip from Glencoe, IL to Champaign, IL

Drive Time

2h 50m

Distance

165.9 mi

267 km

Drive Score

8/10

Great drive

Same Day?

Yes, doable

Fuel Cost

$25

one way

EV Charging

Loading...

station data

Best Time to Leave

Save up to 33 min
4 AM
2h 39m ★
6 AM
2h 50m
8 AM
3h 12m
10 AM
2h 58m
12 PM
2h 56m
3 PM
2h 59m
5 PM
3h 11m
8 PM
2h 44m

Estimated drive times based on typical traffic patterns. Actual times may vary with weather, construction, and real-time conditions.

Downtown Glencoe, IL, IL

Glencoe, IL

Rino Adamo

Trip Overview

Spanning 165.9 miles, this drive from Glencoe to Champaign takes approximately 2 hours and 50 minutes to complete. Because the duration is relatively short, you can comfortably finish this trip in a single day without needing an overnight stay. Your journey will primarily take you along Green Bay Road, Dundee Road, and I-94 East. With an estimated fuel cost of $25, it is a budget-friendly way to travel through the Illinois Midwest. Whether you are heading south for a weekend or a quick visit, the route offers a straightforward connection between these two locations.

Trip Pace

Same-day drive is realistic

A same-day return is realistic if you keep stops short.

Break Rhythm

1 planned break

A short stop every 2 to 3 hours is enough for this drive.

Midpoint

83 miles from Glencoe, IL

A natural place for your longest stop of the day , about 1h 25m into the drive .

Drive Character

Expect a turn-heavy local drive rather than a monotonous interstate cruise. Since the route features 0% highway share, you will spend your time navigating local roads rather than high-speed lanes. This setup keeps you engaged behind the wheel as you transition through various local intersections and turns. The personality of this drive is defined by its technical nature, requiring your full attention as you move away from the Glencoe area toward Champaign. Prepare for a steady pace that favors local navigation over long-distance highway stretches.

This route has more turning and local-road decision points than a simple highway run.
There are about 15 navigation steps in the underlying route data, so the final approach matters more than the middle miles.
Green Bay Road is one of the defining roads on this drive.

How Hard Is This Drive?

Expect a hands-on drive with frequent turns and local roads rather than long highway stretches. Navigation is very simple — set it and forget it for most of the drive.

Route Complexity 1/10

Very easy - short and simple to drive

The drive from Glencoe, IL to Champaign, IL is easy. At 2h 50m with 0% highway, most drivers will find it relaxed and low-stress.

Where does it get tricky?

This route does not have any notably tricky sections. Most of the drive from Glencoe, IL to Champaign, IL is straightforward, with well-signed roads and simple exits.

Main Roads

Road Distance Duration
Green Bay Road Unavailable Refreshing
Dundee Road Unavailable Refreshing
I 94 East Unavailable Refreshing
Edens Expressway Unavailable Refreshing
Kennedy Expressway Unavailable Refreshing
Dan Ryan Expressway Unavailable Refreshing
Dan Ryan Expressway (Express) Unavailable Refreshing
I 57 South Unavailable Refreshing

Per-road distance and duration are being refreshed from OSRM for this route.

Longest stretch: Green Bay Road — detailed segment metrics are refreshing.

Turn-by-Turn Driving Directions

Step-by-step road directions between Glencoe, IL and Champaign, IL.

1

Start on the route

0.2 mi · 1 min · the route
2

Turn right onto Green Bay Road

0.2 mi · 34 sec · Green Bay Road
3

Turn left onto Dundee Road

1.5 mi · 3 min · Dundee Road
4

Take the ramp slight right toward I 94 East, US 41 South: Chicago

0.2 mi · 25 sec · I 94 East, US 41 South: Chicago
5

Merge slight left onto Edens Expressway

13 mi · 17 min · Edens Expressway
6

Continue on Kennedy Expressway

8.1 mi · 11 min · Kennedy Expressway
7

Continue on Dan Ryan Expressway

2.4 mi · 2 min · Dan Ryan Expressway
8

Keep slight left to continue on Dan Ryan Expressway (Express)

8.8 mi · 11 min · Dan Ryan Expressway (Express)
9

Keep slight right to continue on I 57 South: Memphis

118 mi · 2 hr 11 min · I 57 South: Memphis
10

Take the exit slight right toward Market Street

0.3 mi · 27 sec · Market Street
11

Turn left

95 ft · 5 sec
12

Turn left onto Market Street

3.9 mi · 6 min · Market Street
13

Turn right onto East Bradley Avenue

0.3 mi · 34 sec · East Bradley Avenue
14

Turn left onto North Neil Street

0.7 mi · 1 min · North Neil Street
15

Arrive at your destination

Trip Plan

Since you are planning for a 2-hour and 50-minute drive, try to depart during off-peak hours to avoid potential local traffic congestion on Green Bay and Dundee Roads. With only one recommended stop, you have plenty of flexibility to stretch your legs whenever it suits your schedule. Keep your fuel budget of $25 in mind as you plan your departure, and ensure your vehicle is prepped for a route that relies heavily on local roads. A helpful tip for this specific drive is to double-check your GPS settings before leaving, as the abundance of turns on local roads can make navigation trickier than a standard interstate route.

Morning Departure

Leave by 9 AM and you'll arrive before lunch.

Evening Departure

Even a 4 PM departure gets you there before dark in summer.

You can normally do this drive in one day.
Plan roughly 1 meaningful break for fuel, food, and rest.
The halfway point lands around 83 miles from Glencoe, IL, or about 1h 25m into the drive.

This is a comfortable same-day trip.

Departure

Before you leave

Start with fuel, water, and navigation already sorted so the first hour feels easy.

First stop

Around 80 miles or 1h 22m in

Use this first pause for coffee, a restroom break, and a quick traffic check ahead.

Halfway reset

Around 83 miles or 1h 25m in

This is the best place for your longest stop, a real meal, and a full fuel check.

Final approach

Final hour starts around 2h 19m

Traffic, exits, and arrival timing usually matter more near Champaign, IL than in the middle of the route.

Before You Leave

+

Open the route before leaving Glencoe, IL so your first major turns are already loaded.

+

Leave with enough water and a charging cable within reach, not packed away.

+

Check your fuel range against the first long segment, especially if you are starting outside city service areas.

Day 1

Settle into the route from Glencoe, IL

This is one driving day of about 165.9 miles and 2h 50m.

Your first comfortable stop window is around 80 miles from Glencoe, IL.
This route can stay practical as a one-day drive if traffic stays reasonable.
Plan about 1 real break rather than only quick fuel stops.

Where to Stop

Rest stops, refuel points, and overnight suggestions along this route.

Halfway Point

Midpoint

About 83 mi from Glencoe, IL · 1h 25m into the drive

Downtown Orland Park, IL, IL

Mid-route town

Meal stop

Orland Park, IL

83 mi into the route

Best for: Lunch, fuel, and a longer reset

This sits close to the middle of the route, so it works well for the longest stop of the day.

Pacing Suggestions

Orland Park, IL

Fuel and coffee

A short stop after about 80 miles helps settle the day before fatigue starts building.

Orland Park, IL

Meal break

The midpoint is around 83 miles from Glencoe, IL, which is a good place for a longer meal and fuel stop.

Arriving in Champaign, IL

The final approach into Champaign, IL usually feels slower than the middle of the drive, so avoid planning your tightest schedule at the very end.

Try to arrive with enough fuel left to skip an immediate station stop unless you already know the area around Champaign, IL.

These stop ideas are pacing suggestions — the exact town or exit can change with traffic, hotel plans, and fuel range.

Fuel & Cost

Regular Gas

$25.20 one way

$50.40 round trip

$3.86/gal 25.4 MPG avg 58 kg CO2
Fuel Type $/gal One Way Round Trip
midgrade $4.25 $27.78 $55.56
premium $4.80 $31.32 $62.64
diesel $5.64 $36.86 $73.71

No toll roads detected on this route.

Estimated Trip Cost (one way, 1 person)

Fuel

$25

Meals

$25–$50

Total

$50–$75

Rough estimate based on US averages. Hotel $80–$140/night, meals $25–$50/day.

Estimated CO2 emission: 58 kg one way. Prices: EIA weekly data, 2026-04-06.

Driving Electric?

About $17 in charging · 0 stops · 67% less CO2

Vehicle Type kWh Stops DC Fast Home Charge
Average EV 49.8 0 $17.42 $7.96
Efficient EV 41.5 0 $14.52 $6.64
EV Truck/SUV 66.4 0 $23.23 $10.62

Gas CO2

58 kg

EV CO2

19 kg (67% less)

This trip is well within single-charge range for most EVs. No charging stops needed if you start fully charged.

DC fast charging avg $0.35/kWh. Home charging avg $0.16/kWh. US grid CO2: 0.39 kg/kWh.

Travel Intel

Current conditions at both ends of the drive.

Forecast data refreshed 3 days ago

Origin

Glencoe, IL

Morning in Glencoe on Monday

Local time

8:40 AM

CDT

Current temp

50°F

Unavailable

Live forecast

Destination

Champaign, IL

Morning in Champaign on Monday

Local time

8:40 AM

CDT

Current temp

54°F

Unavailable

Live forecast

Seasonal Notes

Summer travel usually means heavier construction, hotter rest stops, and busier weekend traffic around major cities.

Winter travel shortens daylight, so a route that looks manageable on paper can feel much longer after dark.

Holiday weekends tend to make both departure and arrival windows slower than the raw route time suggests.

Time zone

Same local time

Origin and destination are on the same clock, so arrival timing is easier to judge at a glance.

Temperature spread

4 degrees warmer at arrival

A meaningful temperature swing is a good cue to rethink layers, water, and how soon you want to arrive.

Road read

2h 50m on the road

Use the two city cards together: check the sky where you start, then compare it with the local time and temperature at arrival.

Weather data from the National Weather Service. Conditions may change; check closer to your travel date.

Frequently Asked Questions

The drive from Glencoe, IL to Champaign, IL covers 165.9 miles and takes about 2h 50m without stops. Add 15-30 minutes for a fuel or rest stop on longer drives.
The main roads are Green Bay Road, Dundee Road, I 94 East. Expect a mix of highway and local road driving.
This is a comfortable same-day trip.
The midpoint is about 83 miles from Glencoe, IL. Look for rest areas, gas stations, or food options near the halfway mark.
At current regular gas prices, expect to spend about $25.20 one way. This estimate uses 25.4 MPG — your actual cost will vary with your vehicle's fuel efficiency and current gas prices.
Leave by 9 AM and you'll arrive before lunch. Even a 4 PM departure gets you there before dark in summer.
Plan about 1 meaningful break for fuel, food, or rest. A short stop every 2 to 3 hours is enough for this drive.
The drive from Glencoe, IL to Champaign, IL is easy. At 2h 50m with 0% highway, most drivers will find it relaxed and low-stress.
This route does not have any notably tricky sections. Most of the drive from Glencoe, IL to Champaign, IL is straightforward, with well-signed roads and simple exits.
The route from Glencoe, IL to Champaign, IL does not surface many named destination signs beyond the main corridor.

Was this route helpful?

Thanks for your feedback!

Your tip has been submitted. Thanks!

/500

Explore More

Return Trip

Champaign, IL to Glencoe, IL

Plan the drive back the other way.

157.2 mi 3h 10m

Explore more options from Glencoe, IL or browse trips ending in Champaign, IL.

Looking for more statewide routes? Browse IL road trips.

Explore maps for Glencoe, IL or Champaign, IL on MapSof.net.