Skip to main content

Trip from Irwin, PA to Altoona, PA

Data updated 1 second ago

Drive Time

1h 59m

Distance

86.7 mi

139 km

Drive Score

7/10

Good drive

Same Day?

Yes, doable

Fuel Cost

$14

one way

EV Charging

Loading...

station data

Best Time to Leave

Save up to 26 min
4 AM
1h 51m ★
6 AM
2h 0m
8 AM
2h 17m
10 AM
2h 6m
12 PM
2h 4m
3 PM
2h 7m
5 PM
2h 16m
8 PM
1h 54m

Estimated drive times based on typical traffic patterns. Actual times may vary with weather, construction, and real-time conditions.

borough of Pennsylvania

Irwin, PA

Wikimedia Commons

Trip Overview

If you are planning a trip from Irwin to Altoona, expect a straightforward journey covering 86.7 miles. You should set aside roughly 1 hour and 59 minutes of drive time for this trek across Pennsylvania. Since the route is manageable in a single day, there is no need to worry about overnight lodging. Budget about $14 for fuel to cover the distance comfortably. Because this trip relies on local roads rather than major interstates, it offers a more grounded experience for those looking to avoid high-speed traffic. Both the origin and destination are located within the Northeast region, keeping the cultural and geographic feel consistent throughout your travels.

Trip Pace

Same-day drive is realistic

A same-day return is realistic if you keep stops short.

Break Rhythm

0 planned breaks

A short stop every 2 to 3 hours is enough for this drive.

Midpoint

43.3 miles from Irwin, PA

A natural place for your longest stop of the day , about 59m into the drive .

Loading map...

Drive Character

Prepare for a turn-heavy local drive that demands your full attention behind the wheel. Unlike a monotonous interstate slog, this route relies on Lombard Street, the Lincoln Highway, and Amos K, maintaining a 0% highway share throughout the 86.7-mile distance. You will find yourself navigating technical local roads rather than cruising along fast, uninterrupted stretches. Because the road dynamics change frequently, the drive requires a more active, hands-on approach to steering. Expect a steady, winding pace as you traverse these regional roads toward your destination in Altoona.

This route has more turning and local-road decision points than a simple highway run.
There are about 19 navigation steps in the underlying route data, so the final approach matters more than the middle miles.
Lombard Street is one of the defining roads on this drive.

How Hard Is This Drive?

Expect a hands-on drive with frequent turns and local roads rather than long highway stretches. Navigation is very simple — set it and forget it for most of the drive.

Route Complexity 1/10

Very easy - short and simple to drive

The drive from Irwin, PA to Altoona, PA is easy. At 1h 59m with 0% highway, most drivers will find it relaxed and low-stress.

Where does it get tricky?

This route does not have any notably tricky sections. Most of the drive from Irwin, PA to Altoona, PA is straightforward, with well-signed roads and simple exits.

Main Roads

Road Distance Duration
Lombard Street Unavailable Refreshing
Lincoln Highway Unavailable Refreshing
Amos K Unavailable Refreshing
US 22 East Unavailable Refreshing
William Penn Highway Unavailable Refreshing
Admiral Peary Highway Unavailable Refreshing
I 99 Unavailable Refreshing
I 99 North Unavailable Refreshing

Per-road distance and duration are being refreshed from OSRM for this route.

Longest stretch: Lombard Street — detailed segment metrics are refreshing.

Turn-by-Turn Driving Directions

Step-by-step road directions between Irwin, PA and Altoona, PA.

1

Start on the route

203 ft · 19 sec · the route
2

Turn right onto Lombard Street

285 ft · 19 sec · Lombard Street
3

Turn left onto Lincoln Highway

5.9 mi · 11 min · Lincoln Highway
4

Turn left

0.6 mi · 1 min
5

Merge slight left onto Amos K. Hutchinson Bypass

6.0 mi · 6 min · Amos K. Hutchinson Bypass
6

Continue straight

0.3 mi · 36 sec
7

Take the exit slight right toward US 22 East: Blairsville

0.3 mi · 49 sec · US 22 East: Blairsville
8

Merge slight left onto William Penn Highway

34 mi · 47 min · William Penn Highway
9

Continue on Admiral Peary Highway

14 mi · 19 min · Admiral Peary Highway
10

Continue on William Penn Highway

17 mi · 19 min · William Penn Highway
11

Continue on I 99, US 220: Altoona, Bedford

0.5 mi · 45 sec · I 99, US 220: Altoona, Bedford
12

Keep slight left to continue on I 99 North, US 220 North: Altoona

0.9 mi · 1 min · I 99 North, US 220 North: Altoona
13

Merge slight left

4.4 mi · 4 min
14

Take the exit slight right toward 17th Street

0.5 mi · 1 min · 17th Street
15

Keep slight right to continue on Altoona

0.2 mi · 22 sec · Altoona
16

Turn straight onto 17th Street

1.4 mi · 2 min · 17th Street
17

Turn right onto 6th Avenue

0.7 mi · 1 min · 6th Avenue
18

Turn left onto 7th Street

0.2 mi · 19 sec · 7th Street
19

Arrive at your destination

Trip Plan

For the smoothest experience, plan your departure during daylight hours to better navigate the frequent turns on these local roads. Since the total drive time is just under two hours, you have plenty of flexibility to adjust your start time without needing a rigid multi-day itinerary. Keep a close eye on your fuel gauge, as the $14 estimate provides a good baseline, though local road conditions can sometimes impact efficiency. Given the lack of scheduled stops in the route data, consider mapping out your own breaks along the Lincoln Highway if you prefer to stretch your legs. Staying alert is key, as the technical nature of these roads makes them less forgiving than a standard highway.

Morning Departure

Leave by 9 AM and you'll arrive before lunch.

Evening Departure

Even a 4 PM departure gets you there before dark in summer.

You can normally do this drive in one day.
You may only need one short stretch break if traffic stays light.
The halfway point lands around 43.3 miles from Irwin, PA, or about 59m into the drive.

This is a comfortable same-day trip.

Departure

Before you leave

Start with fuel, water, and navigation already sorted so the first hour feels easy.

First stop

Around 80 miles or 1h 50m in

Use this first pause for coffee, a restroom break, and a quick traffic check ahead.

Halfway reset

Around 43.3 miles or 59m in

This is the best place for your longest stop, a real meal, and a full fuel check.

Final approach

Final hour starts around 1h 41m

Traffic, exits, and arrival timing usually matter more near Altoona, PA than in the middle of the route.

Before You Leave

+

Open the route before leaving Irwin, PA so your first major turns are already loaded.

+

Leave with enough water and a charging cable within reach, not packed away.

+

Check your fuel range against the first long segment, especially if you are starting outside city service areas.

Day 1

Settle into the route from Irwin, PA

This is one driving day of about 86.7 miles and 1h 59m.

Your first comfortable stop window is around 80 miles from Irwin, PA.
This route can stay practical as a one-day drive if traffic stays reasonable.
You may only need one short stretch stop if conditions stay smooth.

Where to Stop

Rest stops, refuel points, and overnight suggestions along this route.

Halfway Point

Midpoint

About 43.3 mi from Irwin, PA · 59m into the drive

city in Chautauqua County, New York, United States

Mid-route town

Meal stop

Jamestown, NY

43 mi into the route

Best for: Lunch, fuel, and a longer reset

This sits close to the middle of the route, so it works well for the longest stop of the day.

Pacing Suggestions

Jamestown, NY

Fuel and coffee

A short stop after about 80 miles helps settle the day before fatigue starts building.

Jamestown, NY

Meal break

The midpoint is around 43.3 miles from Irwin, PA, which is a good place for a longer meal and fuel stop.

Arriving in Altoona, PA

The final approach into Altoona, PA usually feels slower than the middle of the drive, so avoid planning your tightest schedule at the very end.

Try to arrive with enough fuel left to skip an immediate station stop unless you already know the area around Altoona, PA.

These stop ideas are pacing suggestions — the exact town or exit can change with traffic, hotel plans, and fuel range.

Fuel & Cost

Regular Gas

$14.37 one way

$28.75 round trip

$4.21/gal 25.4 MPG avg 30 kg CO2
Fuel Type $/gal One Way Round Trip
midgrade $4.61 $15.74 $31.49
premium $4.93 $16.81 $33.63
diesel $5.61 $19.14 $38.28

No toll roads detected on this route.

Estimated Trip Cost (one way, 1 person)

Fuel

$14

Meals

$25–$50

Total

$39–$64

Rough estimate based on US averages. Hotel $80–$140/night, meals $25–$50/day.

Estimated CO2 emission: 30.3 kg one way. Prices: EIA weekly data, 2026-04-13.

Driving Electric?

About $9 in charging · 0 stops · 67% less CO2

Vehicle Type kWh Stops DC Fast Home Charge
Average EV 26 0 $9.10 $4.16
Efficient EV 21.7 0 $7.59 $3.47
EV Truck/SUV 34.7 0 $12.14 $5.55

Gas CO2

30 kg

EV CO2

10 kg (67% less)

This trip is well within single-charge range for most EVs. No charging stops needed if you start fully charged.

DC fast charging avg $0.35/kWh. Home charging avg $0.16/kWh. US grid CO2: 0.39 kg/kWh.

Travel Intel

Current conditions at both ends of the drive.

Forecast data refreshed 1 day ago

Origin

Irwin, PA

Late night in Irwin on Wednesday

Local time

12:21 AM

EDT

Current temp

57°F

Unavailable

Live forecast

Destination

Altoona, PA

Late night in Altoona on Wednesday

Local time

12:21 AM

EDT

Current temp

54°F

Unavailable

Live forecast

Seasonal Notes

Summer travel usually means heavier construction, hotter rest stops, and busier weekend traffic around major cities.

Winter travel shortens daylight, so a route that looks manageable on paper can feel much longer after dark.

Holiday weekends tend to make both departure and arrival windows slower than the raw route time suggests.

Time zone

Same local time

Origin and destination are on the same clock, so arrival timing is easier to judge at a glance.

Temperature spread

3 degrees cooler at arrival

A meaningful temperature swing is a good cue to rethink layers, water, and how soon you want to arrive.

Road read

1h 59m on the road

Use the two city cards together: check the sky where you start, then compare it with the local time and temperature at arrival.

Weather data from the National Weather Service. Conditions may change; check closer to your travel date.

Frequently Asked Questions

The drive from Irwin, PA to Altoona, PA covers 86.7 miles and takes about 1h 59m without stops. Add 15-30 minutes for a fuel or rest stop on longer drives.
The main roads are Lombard Street, Lincoln Highway, Amos K. Expect a mix of highway and local road driving.
This is a comfortable same-day trip.
The midpoint is about 43.3 miles from Irwin, PA. Look for rest areas, gas stations, or food options near the halfway mark.
At current regular gas prices, expect to spend about $14.37 one way. This estimate uses 25.4 MPG — your actual cost will vary with your vehicle's fuel efficiency and current gas prices.
Leave by 9 AM and you'll arrive before lunch. Even a 4 PM departure gets you there before dark in summer.
The drive from Irwin, PA to Altoona, PA is easy. At 1h 59m with 0% highway, most drivers will find it relaxed and low-stress.
This route does not have any notably tricky sections. Most of the drive from Irwin, PA to Altoona, PA is straightforward, with well-signed roads and simple exits.
The route from Irwin, PA to Altoona, PA does not surface many named destination signs beyond the main corridor.

Was this route helpful?

Thanks for your feedback!

Your tip has been submitted. Thanks!

/500

Explore More

Explore more options from Irwin, PA or browse trips ending in Altoona, PA.

Looking for more statewide routes? Browse PA road trips.

Explore maps for Irwin, PA or Altoona, PA on MapSof.net.