Origin
Sandy, UT
Afternoon in Sandy on Sunday
Local time
1:57 PM
MDT
Current temp
42°F
Unavailable
Live forecast
Trip from Sandy, UT to Milford, UT
Drive Time
3h 49m
Distance
217.5 mi
350 km
Drive Score
9/10
Great drive
Same Day?
Yes, doable
Fuel Cost
$34
one way
Best Time to Leave
4 AM
3h 37m
★
6 AM
3h 50m
8 AM
4h 15m
10 AM
3h 59m
12 PM
3h 56m
3 PM
4h 0m
5 PM
4h 14m
8 PM
3h 42m
Estimated drive times based on typical traffic patterns. Actual times may vary with weather, construction, and real-time conditions.
Sandy, UT
Jan Kopřiva
Milford, UT
A K
Trip Overview
If you are planning to travel from Sandy to Milford, expect a 217.5-mile journey that typically takes about 3 hours and 49 minutes to complete. This trip is best suited as a single-day excursion, as the distance is manageable for most drivers without requiring an overnight stay. You will navigate through the Mountain West by utilizing local roads like State Street, 9000 South, and the Veterans Memorial Highway. Budgeting approximately $33 for fuel will keep you covered for the duration of the trip. Since this route stays entirely within Utah, you can anticipate a consistent regional feel throughout your travel.
Trip Pace
Same-day drive is realistic
A same-day return is realistic if you keep stops short.
Break Rhythm
1 planned break
A short stop every 2 to 3 hours is enough for this drive.
Midpoint
108.8 miles from Sandy, UT
A natural place for your longest stop of the day , about 1h 54m into the drive .
Drive Character
Prepare for a turn-heavy local drive that demands your full attention behind the wheel. Unlike a monotonous interstate slog, this route features zero highway miles, meaning you will be navigating surface streets and local connectors for the entire 217.5-mile duration. Because the longest stretch on State Street is 0 miles, you should be ready for frequent adjustments rather than long periods of cruise control. The road's personality is defined by its technical nature, keeping you engaged as you transition between the various local thoroughfares that make up this path.
This route has more turning and local-road decision points than a simple highway run.
There are about 10 navigation steps in the underlying route data, so the final approach matters more than the middle miles.
State Street is one of the defining roads on this drive.
How Hard Is This Drive?
Expect a hands-on drive with frequent turns and local roads rather than long highway stretches. There are only a few real navigation decisions along the way.
Route Complexity
3/10
Easy - simple navigation with a manageable amount of wheel time
This is a straightforward 3h 49m drive. You will face about 0 decision points, but nothing that requires special attention if you follow navigation.
Where does it get tricky?
This route does not have any notably tricky sections. Most of the drive from Sandy, UT to Milford, UT is straightforward, with well-signed roads and simple exits.
Main Roads
| Road | Distance | Duration |
|---|---|---|
| State Street | Unavailable | Refreshing |
| 9000 South | Unavailable | Refreshing |
| Veterans Memorial Highway | Unavailable | Refreshing |
| SR 160 | Unavailable | Refreshing |
| North Main Street | Unavailable | Refreshing |
| West Center Street | Unavailable | Refreshing |
| Main Street | Unavailable | Refreshing |
Per-road distance and duration are being refreshed from OSRM for this route.
Longest stretch:
State Street
— detailed segment metrics are refreshing.
Turn-by-Turn Driving Directions
Step-by-step road directions between Sandy, UT and Milford, UT.
1
Start on 8800 South
0.4 mi
·
1 min
·
8800 South
2
At the end of the road, turn left onto State Street
0.2 mi
·
26 sec
·
State Street
3
Turn right onto 9000 South
0.5 mi
·
59 sec
·
9000 South
4
Take the ramp slight left
0.4 mi
·
56 sec
5
Merge slight left onto Veterans Memorial Highway
183 mi
·
3 hr 3 min
·
Veterans Memorial Highway
6
Take the exit slight right toward SR 160: Beaver
0.3 mi
·
46 sec
·
SR 160: Beaver
7
Turn left onto North Main Street
1.8 mi
·
3 min
·
North Main Street
8
Turn right onto West Center Street
30 mi
·
36 min
·
West Center Street
9
Continue on Main Street
0.7 mi
·
1 min
·
Main Street
10
Arrive at your destination
Trip Plan
Since you have one planned stop along the way, use that time to stretch your legs and refuel before finishing the final leg of your 3-hour and 49-minute drive. Given the turn-heavy nature of this route, leaving early in the day allows you to navigate the local roads during daylight hours when visibility is best. Keep your $33 fuel budget in mind as you plan your stops, as local road driving can sometimes be less fuel-efficient than high-speed highway cruising. The primary advantage here is the flexibility of a one-day trip, so don't feel pressured to rush through the local sections. A concrete tip for this journey: keep a real-time navigation app running, as the heavy reliance on local roads like 9000 South and State Street involves many turns that can be easy to miss.
Morning Departure
An early start around 7-8 AM gets you there with plenty of daylight left.
Evening Departure
A late afternoon start means arriving after dark. Morning is better.
You can normally do this drive in one day.
Plan roughly 1 meaningful break for fuel, food, and rest.
The halfway point lands around 108.8 miles from Sandy, UT, or about 1h 54m into the drive.
This is a comfortable same-day trip.
Departure
Before you leave
Start with fuel, water, and navigation already sorted so the first hour feels easy.
First stop
Around 80 miles or 1h 24m in
Use this first pause for coffee, a restroom break, and a quick traffic check ahead.
Halfway reset
Around 108.8 miles or 1h 54m in
This is the best place for your longest stop, a real meal, and a full fuel check.
Final approach
Final hour starts around 3h 8m
Traffic, exits, and arrival timing usually matter more near Milford, UT than in the middle of the route.
Before You Leave
+
Open the route before leaving Sandy, UT so your first major turns are already loaded.
+
Leave with enough water and a charging cable within reach, not packed away.
+
Check your fuel range against the first long segment, especially if you are starting outside city service areas.
Day 1
Settle into the route from Sandy, UT
This is one driving day of about 217.5 miles and 3h 49m.
Your first comfortable stop window is around 80 miles from Sandy, UT.
This route can stay practical as a one-day drive if traffic stays reasonable.
Plan about 1 real break rather than only quick fuel stops.
Where to Stop
Rest stops, refuel points, and overnight suggestions along this route.
Halfway Point
Midpoint
About 108.8 mi from Sandy, UT · 1h 54m into the drive
Mid-route town
Meal stop
109 mi into the route
Best for: Lunch, fuel, and a longer reset
This sits close to the middle of the route, so it works well for the longest stop of the day.
Pacing Suggestions
Fuel and coffee
A short stop after about 80 miles helps settle the day before fatigue starts building.
Meal break
The midpoint is around 108.8 miles from Sandy, UT, which is a good place for a longer meal and fuel stop.
Arriving in Milford, UT
The final approach into Milford, UT usually feels slower than the middle of the drive, so avoid planning your tightest schedule at the very end.
Try to arrive with enough fuel left to skip an immediate station stop unless you already know the area around Milford, UT.
These stop ideas are pacing suggestions — the exact town or exit can change with traffic, hotel plans, and fuel range.
Fuel & Cost
Regular Gas
$34.47 one way
$68.93 round trip
$4.03/gal
25.4 MPG avg
76 kg CO2
| Fuel Type | $/gal | One Way | Round Trip |
|---|---|---|---|
| midgrade | $4.23 | $36.23 | $72.46 |
| premium | $4.53 | $38.78 | $77.56 |
| diesel | $5.64 | $48.32 | $96.64 |
No toll roads detected on this route.
Estimated Trip Cost (one way, 1 person)
Fuel
$34
Meals
$25–$50
Total
$59–$84
Rough estimate based on US averages. Hotel $80–$140/night, meals $25–$50/day.
Estimated CO2 emission: 76.1 kg one way. Prices: EIA weekly data, 2026-04-06.
Driving Electric?
About $23 in charging · 0 stops · 67% less CO2
| Vehicle Type | kWh | Stops | DC Fast | Home Charge |
|---|---|---|---|---|
| Average EV | 65.3 | 0 | $22.84 | $10.44 |
| Efficient EV | 54.4 | 0 | $19.03 | $8.70 |
| EV Truck/SUV | 87 | 1 | $30.45 | $13.92 |
Gas CO2
76 kg
EV CO2
25 kg (67% less)
Plan for 0 charging stops, roughly every 270 miles. Allow 25-40 minutes per stop at a DC fast charger.
DC fast charging avg $0.35/kWh. Home charging avg $0.16/kWh. US grid CO2: 0.39 kg/kWh.
Travel Intel
Current conditions at both ends of the drive.
Destination
Milford, UT
Afternoon in Milford on Sunday
Local time
1:57 PM
MDT
Current temp
35°F
Unavailable
Live forecast
Seasonal Notes
Summer travel usually means heavier construction, hotter rest stops, and busier weekend traffic around major cities.
Winter travel shortens daylight, so a route that looks manageable on paper can feel much longer after dark.
Holiday weekends tend to make both departure and arrival windows slower than the raw route time suggests.
Time zone
Same local time
Origin and destination are on the same clock, so arrival timing is easier to judge at a glance.
Temperature spread
7 degrees cooler at arrival
A meaningful temperature swing is a good cue to rethink layers, water, and how soon you want to arrive.
Road read
3h 49m on the road
Use the two city cards together: check the sky where you start, then compare it with the local time and temperature at arrival.
Weather data from the National Weather Service. Conditions may change; check closer to your travel date.
Frequently Asked Questions
The drive from Sandy, UT to Milford, UT covers 217.5 miles and takes about 3h 49m without stops. Add 15-30 minutes for a fuel or rest stop on longer drives.
The main roads are State Street, 9000 South, Veterans Memorial Highway. Expect a mix of highway and local road driving.
This is a comfortable same-day trip.
The midpoint is about 108.8 miles from Sandy, UT. Look for rest areas, gas stations, or food options near the halfway mark.
At current regular gas prices, expect to spend about $34.47 one way. This estimate uses 25.4 MPG — your actual cost will vary with your vehicle's fuel efficiency and current gas prices.
An early start around 7-8 AM gets you there with plenty of daylight left. A late afternoon start means arriving after dark. Morning is better.
Plan about 1 meaningful break for fuel, food, or rest. A short stop every 2 to 3 hours is enough for this drive.
This is a straightforward 3h 49m drive. You will face about 0 decision points, but nothing that requires special attention if you follow navigation.
This route does not have any notably tricky sections. Most of the drive from Sandy, UT to Milford, UT is straightforward, with well-signed roads and simple exits.
The route from Sandy, UT to Milford, UT does not surface many named destination signs beyond the main corridor.
Was this route helpful?
Thanks for your feedback!
Your tip has been submitted. Thanks!
/500
Recent Tips
·
Explore More
Continue From Milford, UT
More trips to Milford, UT
Explore more options from Sandy, UT or browse trips ending in Milford, UT.
Looking for more statewide routes? Browse UT road trips.
Explore maps for Sandy, UT or Milford, UT on MapSof.net.